A Website for Mobile Home Residents

by Mobile Home Residents

Mobile Home Resident

How to Replace Skirting on a Mobile Home

 

If you own a mobile home, you may find that over time the skirting around the bottom of your home can become damaged or worn out. Skirting is an important part of a mobile home as it helps to protect the underside of the home from the elements and pests. If your skirting is in need of replacement, you can easily do it yourself with a few tools and materials. In this article, I'll guide you through the process of replacing skirting on a mobile home.

 

Materials Needed:

 

- New skirting panels

- J-channel

- Screws

- Drill

- Circular saw

- Tape measure

- Level

- Hammer

- Nails

- Caulk

 

Step 1: Remove the Old Skirting

The first step in replacing skirting on a mobile home is to remove the old skirting. Start by removing any trim pieces or molding around the bottom of the home. Use a pry bar or hammer to gently pry off the old skirting panels. Be careful not to damage the siding or insulation underneath the skirting.

 

Step 2: Measure and Cut New Skirting Panels

Once the old skirting is removed, measure the length of each section where the new skirting panels will be installed. Use a tape measure to get an accurate measurement. Transfer these measurements to the new skirting panels and use a circular saw to cut them to size.

 

Step 3: Install J-Channel

Next, install J-channel along the top of each section where the new skirting panels will be installed. The J-channel will hold the top edge of the skirting panels in place. Use screws to secure the J-channel to the bottom of the home, making sure it is level.

 

Step 4: Install Skirting Panels

Now it's time to install the new skirting panels. Start at one end and slide the bottom edge of the panel into the J-channel. Use screws to secure the panel to the home, making sure it is level. Continue installing panels in this manner until the entire section is covered.

 

Step 5: Trim and Finish

Once all the skirting panels are installed, trim any excess material with a circular saw. Install trim pieces or molding around the bottom of the home to give it a finished look. Use caulk to seal any gaps between the skirting panels and the home to prevent moisture and pests from getting in.

 

Step 6: Final Touches

Finally, step back and admire your handiwork! Your mobile home now has fresh, new skirting that will protect it for years to come. Make sure to regularly inspect the skirting for any damage or wear and tear, and replace as needed.

 

In conclusion, replacing skirting on a mobile home is a relatively simple DIY project that can be completed in a weekend. With the right tools and materials, you can give your home a fresh new look and protect it from the elements. Follow the steps outlined in this article to replace skirting on your mobile home and enjoy the benefits of a well-protected home.

 

© Mike Whitty | Mr. Mike's Neighborhood